Problems & solutions of PET bottle molding process, Part 1.

Problems & solutions of PET bottle molding process, Part 1.

18, PET bottles are not straight with the central core

A, Causes:

   1, Too-early air supply

   2, Too high air pressure

   3, The stretch rod is not straight with the mold bottom

   4, Preforms quality problem

   5, Stretch rod is too slow on going down

   6, Stretch rod is too high from the mold bottom

   7, Temperature for the bottom part is too high.

B, Solutions:

   1, Slow down the delay-blow time

   2, Reduce the air pressure

   3, Fix the stretch rod position, around 1-1.5 cm to the bottom.

   4, Get good quality preforms

   5, Adjust the pressure on the stretch cylinder

   6, Reduce the temperature for the bottom part of the bottles

   7, Fix the stretch rod to be in the center.

http://www.sinobema.com/Difference-between-bottles-of-pure-water?article_id=196

From Sino Beverage Machinery Co., Ltd China
施诺机械设备有限公司中国
sinobema@gmail.com
www.sinobema.com 

www.sinobeveragemachinery.com
WhatsApp: 0086 137 28668423